Scope 1, 2 and 3 Emissions: A US, UK and Malaysia Guide



Scope 1, 2, 3 are the three groups in the GHG Protocol Corporate Standard. Direct emissions from sources you own or control sit in Scope 1. Purchased electricity, steam, heat or cooling sit in Scope 2. Then all other indirect value-chain emissions sit in Scope 3. Companies in the US, UK and Malaysia use this structure, but the filing rules for each scope are not the same.
This guide defines each scope, lists the 15 Scope 3 categories, and compares current market duties. It complements our earlier plain-English Scope 3 guide, which focuses on the value chain in more depth. We checked the regulatory points against official sources in November 2026. However, you should recheck those sources before you file.
This article is general information, not legal advice.
What are Scope 1, 2, 3?
In short, Scope 1, 2 and 3 emissions are a way to sort greenhouse gases by where they occur and who controls the source. The split stops two companies from counting the same tonne as Scope 1. In addition, it shows where a company can act directly, and where it must work with suppliers or customers. Official definitions are in the GHG Protocol.
Direct emissions from owned or controlled sources sit in Scope 1. For example, typical sources include fuel in boilers and furnaces, fuel in company vehicles, process emissions, and fugitive releases such as refrigerant leaks. If you do not own or control the source, the figure does not belong here.
Purchased energy sits in Scope 2. In this case, the emissions occur at the power station or the heat plant, not at your site. Still, they are a consequence of the energy you bought. Many companies report both a location-based figure, using average grid factors, and a market-based figure, using contractual instruments such as energy attribute certificates, following the GHG Protocol Scope 2 Guidance.
All other indirect emissions sit in Scope 3. Here, the emissions occur in the value chain, from purchased goods and capital equipment through to the use and end-of-life of sold products. Our earlier Scope 3 article explains why this is often the largest and hardest part.
What are the 15 Scope 3 categories?
The GHG Protocol Scope 3 Standard organises the value chain into 15 categories. These categories are designed to be mutually exclusive, so you do not count the same tonne twice. Still, you do not have to report every category if it is not relevant, but you should say which ones you included and why.
| Upstream categories | Downstream categories |
|---|---|
| 1. Purchased goods and services | 9. Downstream transportation and distribution |
| 2. Capital goods | 10. Processing of sold products |
| 3. Fuel- and energy-related activities not in Scope 1 or 2 | 11. Use of sold products |
| 4. Upstream transportation and distribution | 12. End-of-life treatment of sold products |
| 5. Waste generated in operations | 13. Downstream leased assets |
| 6. Business travel | 14. Franchises |
| 7. Employee commuting | 15. Investments |
| 8. Upstream leased assets |
In practice, most companies start with the categories they can evidence first, such as business travel, waste and fuel- and energy-related activities. Then they work toward purchased goods and, if relevant, the use of sold products. For example, spend-based estimates can open the work, but material categories should move toward activity data over time.
How do Scope 1, 2 and 3 emissions work in a carbon inventory?
First, set the organisational boundary and the reporting period. Then collect activity data and apply recognised emission factors, recording the source and the year. After that, classify each result into the correct scope and, for Scope 3, the correct category. Finally, document estimates and gaps, so a reviewer can test the number.
The Corporate Standard says companies shall report Scope 1 and Scope 2 at a minimum. Scope 3 is optional in that standard itself. However, many later frameworks ask for material Scope 3 categories as well. Therefore, plan the data even if you phase the disclosure. Our carbon accounting guide explains the wider method.
What do the US, UK and Malaysia currently require for Scope 1, 2 and 3?
The GHG Protocol is the common method. By contrast, the filing duty for each scope depends on the entity and the country. The table below is a starting map, not legal advice.
United Kingdom and United States
| Market | Scope 1 and Scope 2 | Scope 3 |
|---|---|---|
| United Kingdom | SECR already requires in-scope quoted companies to report global Scope 1 and Scope 2 figures, and in-scope large unquoted companies and LLPs to report UK energy use and associated emissions. UK SRS will add ISSB-aligned climate disclosure for in-scope listed companies, for periods starting on or after 1 January 2027. | SECR encourages Scope 3 but does not make a full value-chain inventory mandatory for every in-scope entity. Under FCA PS26/19, listed companies have one year of transitional relief for Scope 3 disclosures under UK SRS. |
| United States | The EPA Greenhouse Gas Reporting Program is facility-based, with many reporters at or above 25,000 metric tons of CO2 equivalent, and some source categories reporting regardless of that threshold. California SB 253 Scope 1 and Scope 2 requirements for in-scope large companies were allowed to proceed by the Ninth Circuit on 9 November 2026. | SB 253’s statute pointed to Scope 3 reporting later, but the Ninth Circuit found those requirements likely unconstitutional and remanded severability questions. The 2024 SEC climate rules remain stayed, and the SEC has proposed to rescind them. So a US corporate Scope 3 filing duty is not settled at federal level, and California Scope 3 is in legal flux. |
Malaysia
| Market | Scope 1 and Scope 2 | Scope 3 |
|---|---|---|
| Malaysia | NSRF uses IFRS S1 and S2 as the baseline, with climate-first reporting first. Group 1 began for periods starting on or after 1 January 2025, Group 2 from 1 January 2026, and Group 3 from 1 January 2027. Mandatory reasonable assurance on Scope 1 and Scope 2 for Group 1 is now set for periods beginning on or after 1 January 2028. | Entities in Groups 1 and 2 may omit Scope 3 GHG emissions for the first two annual reporting periods. Group 3 may omit them for the first three. After those reliefs, material Scope 3 information is part of the ISSB-based pack. |
United Kingdom notes
For example, quoted companies are in SECR regardless of size. In addition, UK-incorporated unquoted companies and LLPs are in scope if they are large, meaning they meet at least two of these tests: £36 million turnover, £18 million balance-sheet total, or 250 employees. Official guidance is on GOV.UK. Our SECR reporting guide explains the reports themselves.
For listed companies, the FCA’s PS26/19 rules apply on a comply-or-explain basis, with first reporting in 2028. Accordingly, the one-year Scope 3 relief is useful, but it is not a reason to delay data design. Our UK SRS article covers the standard.
United States notes
There is no single federal corporate inventory filing in force for every company. In addition, facility reporting under the EPA programme is a separate system from a GHG Protocol group inventory, although the same activity data can feed both. Specifically, SB 253 targets US-based entities with more than $1 billion in annual revenue that do business in California, and first-year reporting covers Scope 1 and Scope 2. Our SB 253 guide tracks the court process. You should not treat Scope 3 under that law as fully required or fully repealed until the remaining legal questions are resolved.
Malaysia notes
The NSRF timetable is set out in the IFRS jurisdictional profile and in Securities Commission announcements. Meanwhile, SMEs outside the NSRF groups may still be asked for Scope 1 and Scope 2 figures, and sometimes selected Scope 3 data, by large buyers. In addition, the Simplified ESG Disclosure Guide can help them start. Our ESG reporting Malaysia guide sets out those phases.
How should companies start measuring Scope 1, 2 and 3?
Start with a data map. For Scope 1, gather fuel invoices, fleet records and refrigerant logs. Then, for Scope 2, gather electricity, steam, heat and cooling data, plus any contractual instruments. After that, for Scope 3, list the categories that are likely to be material, then collect the best available data for those first.
Next, keep the trail. Otherwise, a total with no factor source will not survive a serious review. After that, improve estimates each year, especially in purchased goods and use of sold products if they matter to your business. Software can help, as our buyer’s guide and AI carbon accounting article explain. Still, the boundary and the sign-off remain yours.
StarfetchX, an ESG and carbon accounting software platform, is built to help teams organise this inventory work. Even so, the method comes first.
Scope 1, 2 and 3 emissions: frequently asked questions
What is the difference between Scope 1 and Scope 2?
Direct emissions sit in Scope 1. By contrast, Scope 2 is from purchased energy. If you burn gas in your own boiler, that is Scope 1. Meanwhile, electricity you buy from the grid sits in Scope 2.
Why is Scope 3 often larger?
Because it includes suppliers, transport, travel and, in many business models, the use of sold products. In practice, the exact share depends on the sector. Therefore, you should measure your own inventory rather than assume a generic ratio.
Do we have to report all 15 categories?
Not if a category is not relevant. However, you should explain the exclusions. Otherwise, a reader cannot tell whether a low total is complete.
Is Scope 3 mandatory?
It depends on the rule that applies to you. The GHG Protocol Corporate Standard treats it as optional. By contrast, UK SRS, NSRF and some customer requests go further, often after a transition period. California SB 253 Scope 3 is currently in legal flux.
Should we report location-based and market-based Scope 2?
If you have contractual instruments, the Scope 2 Guidance expects both methods. Even so, if a local filing uses one figure, keeping both will make later comparisons easier.
Can we use the same inventory in the US, UK and Malaysia?
Yes, if the method and boundary are consistent. Then you can change the export pack for each filing. In practice, you should still test the local format, including any Scope 3 relief that still applies.
If you want help measuring Scope 1, 2 and 3 emissions, you can contact StarfetchX, an ESG and carbon accounting software platform, through starfetchx.com/contact or at support@starfetchx.com.
Disclaimer: The data, regulations and dates in this article are for general information only and may change. Please recheck the latest official sources for accurate data and up-to-date information before making any decisions. This is not legal or financial advice.